![sony neckband headphones bluetooth sony neckband headphones bluetooth](https://i.ytimg.com/vi/hRe4unPDAsE/maxresdefault.jpg)
If the unit requires a pass code, the passcode is fixed to 0000.The Passcode may also be referred to as Passkey, PIN code, PIN number or Password.If passcode input is required on the display of the Bluetooth audio device, input 0000 (four zeros).NOTE: If the model number of this unit does not display, start over from step 1. Select the model number of this unit shown in the display of the Bluetooth audio device.
![sony neckband headphones bluetooth sony neckband headphones bluetooth](https://allmytech.pk/wp-content/uploads/2020/02/61ALH91fL._SL1500_.jpg)
Depending on the device, Bluetooth connection may start automatically.Some devices cannot display the list of detected devices.The list of detected devices appear on the display of the Bluetooth audio device.Perform the pairing procedure on the Bluetooth audio device to detect this unit.When the POWER (green or red) indicator and the COMMUNICATION STATUS (blue) indicator starts flashing together, release the ID SET button (for the speaker).When pairing for the first time, press and hold the / POWER button for about 2 seconds while the Bluetooth headphones are turned off.If the pairing mode is canceled while performing this procedure, start over from step 1. The pairing mode is canceled and this unit is turned off after about five minutes.The button that must be held down to enter Pairing mode differs depending on the product you use, so check the instruction manual for your Bluetooth headphones.The Bluetooth headphones enter Pairing mode. When the indicator starts to blink quickly, release the button. Press and hold the ID SET button (for the speaker) or the / POWER button (for the headphones) for more than 7 seconds while the Bluetooth headphones are turned off.Turn on the connecting Bluetooth device and place it within 3 feet (1 meter) of this unit.If the unit powers on when you connect it to a power source, press and hold the POWER button to turn the unit off. Verify that the power of the unit is off.Make sure that both devices have sufficient charge or power.Be sure to place the Bluetooth® wireless devices within 1 meter (3 ft) of each other.
SONY NECKBAND HEADPHONES BLUETOOTH MANUALS
Manuals are posted on your model support page. If model-specific information is required to complete any of the steps in this solution, refer to the operating instructions supplied with the product.